Table of Contents
Why does my Raypak pool heater keep shutting off?
If your pool heater keeps turning off and on, check to see if the water flow light on the display is lit up. If your unit doesn’t have this light, then walk over to your filter pump and check the pressure. A few areas to clean & check for blockage include: Your filter pump’s basket.
What does rollout SW Open mean on pool heater?
The rollout switch is activated when something like wind causes the flames to shoot out towards the front of the unit. This is usually caused by high winds while the unit is running.
How old is my Raypak pool heater?
The date code is found in the first four digits of the serial number, for example, a unit made in April of 2001 will have the first four digits read as 0104.
What does SPK mean on pool heater?
SPK means that the heaters safeties are all closed. You have to change the set point above the water temperature in the pool or spa so the heater will light the pilot and prove that it is lit.
Why does my electric pool heater keep shutting off?
A dirty filter can cause low pressure and as a result, cause the heater’s pressure switch to turn OFF. A dirty filter can prevent a heater from firing and it can also cause your heater to shut off before warming the water to the desired temperature.
What is a rollout switch?
A roll-out switch is a safety feature found on a gas furnace. The roll-out switch stops the furnace from igniting if a part of the furnace that is supposed to stay cool gets hot. It’s essentially an alarm system that lets you know the flames in your furnace are going places they should not go.
How do you read a Raypak pool heater serial number?
The rating plate will be either a gold or silver color with the Raypak logo. The serial number will have 10 digits. The date code is found in the first four digits of the serial number, for example, a unit made in April of 2001 will have the first four digits read as 0104.
How long should a pool heater last?
Depending on the climate of the area you live in and what temperature you intend to heat your pool, different systems can last anywhere from 6 to 20+ years.
What to do if your Raypak rp2100 heater goes out?
Turn gas control knob counter-clockwise to “Pilot” 9. Place flame to end of pilot tube. Push in control knob all the way and hold to light pilot. Continue to hold control knob in for about one minute after the pilot is lighted, release knob and it will pop back up. Pilot should remain lighted. If it goes out, repeat steps 5 through 9.
Where is the temperature setting on a Raypak pool heater?
If your heater has been installed correctly, operating the heater is an easy task. The upper front panel of the heater contains the control center that allows you to turn the heater On or Off and adjust the temperature set- tings for the pool or spa. The temperature range is factory set from 65°F (18°C) to 104°F (40°C).
Do you need a check valve on a Raypak water heater?
• Automatic chemical dosing devices and salt chlorinators are usually more efficient in heated water, unless controlled, they can lead to excessive chlorine level which can damage your heater, and which is not covered under warranty. A check valve should be installed between the heater outlet and a chlorinator or other chem – ical dosing device.
What’s the maximum alkalinity of a Raypak heater?
F) 68 to 88 89 to 104 68 to 104 pH 7.3 to 7.4 7.3 to 7.4 7.6 to 7.8 Total Alkalinity (PPM) 120 to 150 120 to 150 80 to 120 Calcium Hardness (PPM) 200 to 300 150 to 200 200 to 400 Salt (PPM)4500 MAXIMUM 4500 MAXIMUM 4500 MAXIMUM