How do I calibrate my MSA Altair?
How do I calibrate the MSA Altair 4X?
- Hold the UP arrow down for 3 seconds until ZERO CAL shows, ensuring you’re in a fresh-air environment whilst doing so.
- This asks if you’d like to go ahead with carrying out a zero calibration.
- Select Yes by pressing the middle button and the Sensor Refresh screen will show.
How do I reset my MSA Altair 4xr?
To reset this alarm, cycle power off and on, in fresh air. Keep the device in the fresh air environment until LEL or CH4 readings have stabilized and then follow the Fresh Air Setup and Zero Calibration instructions contained in this manual.
What does a 5 gas monitor detect?
Detects combustible gases in LEL and/or volume percentage range, oxygen, carbon monoxide, carbon dioxide, hydrogen sulfide, sulfur dioxide, ammonia, chlorine, VOCs, and many others depending upon sensor configuration.
How to calibrate the Altair 5x multi gas detector?
method for calibrating MSHA-approved ALTAIR 5X devices. – Use only calibration gas that is 2.5 % Methane with an accuracy of +5 % when calibrating MSHA-approved ALTAIR 5X devices. – The maximum acceptable user-set [password protected] Galaxy Test System tolerance on Bump Limits must be set to 10 % or less when calibrating MSHA-
Which is automated test stand for MSA Altair?
Easy-to-use automated test stand offers high performance as either stand-alone unit or integrated portable detector management system, enabling total data access and control of the MSA ALTAIR family Gas Detector fleet.
Who is the manufacturer of the Altair 5x?
MSA Declaration of Conformity GB ALTAIR 5X/ALTAIR 5X IR 3 Declaration of Conformity Manufactured by: Mine Safety Appliances Company 1000 Cranberry Woods Drive Cranberry Township, PA 16066 USA The manufacturer or the European Authorized Representative MSA AUER GmbH, Thiemannstrasse 1, D-12059 Berlin declares that the product: ALTAIR 5X, ALTAIR 5XIR
What kind of Kit do I need for MSA?
Kits can accommodate 2 cylinders, regulators, tubing, accessories and instructions. All kits housed in a lightweight carrying case, making it convenient to carry everything directly to the sensor location or job site. The ALTAIR Pump Probe is a rugged sampling accessory for MSA gas detection instruments.