Why is my Zanussi dishwasher flashing?

Posted on by Sherryl Cole

Why is my Zanussi dishwasher flashing?

Zanussi dishwasher error codes have phase indicator lights that flash when there’s a problem. AL5 – this warning light flashing indicates that the appliance isn’t filling with water. The water supply or tap may be cut or turned off. Other issues could be related to the inlet hose, or the filter which may need cleaning.

How do you reset a Zanussi dishwasher?

Resolution

  1. Make sure the door is fully closed. Open and close the door again.
  2. Make sure the delay start function is disabled. Press and hold ‘Reset’ for about 5 seconds.
  3. Check if the previous cycle is still in progress. If a cycle is still in progress it needs to be cancelled before programming the next cycle.

What does the arrow symbol mean on a Zanussi dishwasher?

It means that the system is telling you that there is water in the base of the appliance… For this you should contact Zanussi on #03445-610-645 since your appliance will still be under the initial warranty period.

What Does flashing light on dishwasher mean?

Common solutions for: Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesn’t reach the proper temperature after a set amount of time, a light on the control panel might start flashing. If the heating element does not have continuity, replace it.

How do you reset a Zanussi zdt12011fa dishwasher?

But has you tried to reset it? If not press and hold the start button for several seconds and this should reset the flashing lights.

Why is my Zanussi dishwasher not turning on?

Check if there are tripped relays or blown fuse. Reset the circuit-breaker / RCD device or replace the fuse. You can reset the circuit-breaker by pushing the switch to the “ON” position.

How do I fix my dishwasher from blinking?

Possible Solutions

  1. Reset your dishwasher.
  2. Cancel the child lock function.
  3. Remove sleep mode function.
  4. Check the Delay Start function.
  5. Address door latch issues.
  6. Determine that the water is flowing into the tub.
  7. Check on the water supply valve.
  8. Ensure correct installation.