Table of Contents
How do you reset the security on a 2003 Pontiac Grand Prix?
How to Reset Security on a Pontiac Grand Prix 2003
- Put the key into the ignition and turn it clockwise.
- Turn the ignition counterclockwise and turn it on again if the security light doesn’t appear.
- Insert the original key into the ignition and turn clockwise to turn on the engine.
How do I get my 2004 Pontiac Grand Prix out of theft mode?
hold the lock and unlock on your keyfob together until it honks and flashes the lights. get in and turn the key to on, but don’t start the car. give it a good 30 seconds until the security lights aren’t flashing…you should be able to start after that.
How do I reset my GM Anti theft system?
How to Reset the Passlock System on GM Cars
- Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
- Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.
How to reset the theft system in a Pontiac Grand Prix?
How to Reset the Theft System in a Pontiac Grand Prix. Press and hold the lock and unlock buttons on the keyless entry remote until the horn honks once and the lights flash briefly. Enter the vehicle and insert the ignition key into the ignition. Turn the ignition to the “ON” position but do not start the engine. Wait 30 seconds and start…
How to bypass the PassLock sensor on a 2002 Pontiac Grand Am?
This web page will guide you through the steps necessary to bypass the “Passlock Sensor” on a 2002 Pontiac Grand Am, and keep the “SECURITY” light off forever. The steps necessary are similar on the other models listed above. There are generally only minor differences in how to get the radio out to get to the wires.
What should resistance be for Pontiac PassLock security system?
The resistance should be approximately the same as the resistor you connected into the circuit. (about 2200 ohms. [2.2Kohms]) If not, you have a wiring problem and you will need a wiring diagram for your vehicle to make repairs. You will find the 2002 Pontiac Security System Wiring diagram at the bottom of this article.
How to replace the PassLock sensor on a GM car?
Find the three wires that connect the Passlock Sensor to the Body Control Module and substitute our circuit for the Passlock Sensor. Perform the “Relearn” Procedure so that our Body Control Module recognizes our new circuit. Go to Radio Shack and buy a Mini Terminal Block, and a package of 2200 ohm (2.2k-Ohm) resistors.