Table of Contents
How tight should a skidoo track be?
With around 1-1/2 inch of track deflection with a small amount amount of force pushing down on the track (16 lbs per the manual), that seems to be a good balance of loose enough but not too loose.
What CC is a Yamaha Nytro?
1049 /
2011 Yamaha FX Nytro XTX Specifications
| Identification | |
|---|---|
| Engine Stroke | 4-Stroke |
| Valve Configuration | DOHC |
| Displacement (cc/ci) | 1049 / 64 |
| Starter | Electric |
Is the Yamaha Nytro fuel injected?
Advanced fuel injection Advanced fuel injection Advanced fuel injection The Genesis 130FI uses Yamaha’s advanced fuel injection system to control fuel flow to the engine. Consumers will enjoy the engine’s spot-on performance and throttle response as a result of the advanced electronic fuel injection system.
What do limiter straps do?
Limit straps are vital in custom suspension setups helping to prevent damage to suspension and drivetrain components. Without limit straps, the force of your vehicle’s unsprung weight can cause damage to shocks when jumping or at high speeds over rough sections. Limit straps can also prevent damage to your CV joints.
How to change the track on an FX Nytro?
FX Nytro Track or Gear Change FX Nytro Track or Gear Change By Allen Ulmer -Srxspec Here are some general photos and Ulmers 136″ kit. This is only showing gear and track swap. Time to disassemble the chain case! First removing the plastic panels! Little tabs hold the plastic into place.
Where are the suspension bolts on an FX Nytro?
Lower bolt holding lower gear on (14mm socket). Upper shaft showing spacer & washer against top gear. Showing lower spacer that is behind the gear. Showing upper spacer & washer that is behind the top gear. Rear suspension bolts to remove (14mm socket & wrench).
How do you put a skid back in a Nytro?
If you have to put the rear skid back in you will need to unhook the torsion springs usually to get the rear mounting points to line up! You must have the cover tight before trying to use reverse. The lever should be in the “up” position and come down over the top of the slot in the reverse gear.
How to remove parking brake on FX Nytro?
Need a 10mm socket to remove these (on bottom/underside portion of panel). Lower little tab lock under the running board. More disassembly pics! Draining the chaincase oil (use 12mm socket). Snap Ring & Washer that must be removed for brake disc removal. Bolts to remove parking brake (use 4mm Allen wrench).