What does F01 mean on a Maytag washer?
obstruction in
maytag washer with error code F01 means a obstruction in a hose or tube, not a control panel issue like people say.
How do I fix the F01 code on my Maytag dryer?
Power unit down by turning off the circuit breaker(s) for one (1) minute. Power unit up by turning on the circuit breaker(s). Start a time dry cycle. Monitor the dryer for one (1) minute to ensure the error code does not display again.
How do I fix F01 error?
The Whirlpool Duet Dryer F01 error may be able to be fixed with a simple reset of the main control. Unplug the dryer for 1 minute and plug it back in this will reset the control if the error persists after that you will need to check the dryer thermal fuse.
What does it mean when your dryer says F01?
failed electronic machine control board
7 Answers. The F01 indicates a failed electronic machine control board. This error code can sometimes be caused by a glitch or power surge through the electrical lines. You may be able to clear this code by unplugging the washer for 5 minutes.
What does F mean on washing machine?
The F indicates that the washer control detected a component problem. If the F code was caused by excessive suds preventing the washer from draining, you may be able to shut the door and run a drain/spin cycle to remove the water from the washer.
What is F1 on Maytag dryer?
F1 – Defective touch Pad or Control Board (Clock) – Replace either touch pad, control board, or both if one assembly. Refer to F1 Test for more information. F2 – Oven Temperature Too Hot – Replace relay board (if present) or oven temperature sensor.
Why does dryer say F1?
The Whirlpool Cabrio dryer F1 error flashes when there is a miscommunication between the control board and the rest of your machine. Move your dryer away from the wall so you can access the control panel area. There are 2 screws located in the back of the control panel.
What does F mean on a dryer?
The F-01 error code indicates a primary control failure. The primary controls are located inside the main control panel where the dryer cycles and settings are displayed. Any burns or arcing on the motherboard where the wires are connected could mean the primary control was shorted out.
What does F01 mean on a Maytag dryer?
The “F1” error means that the dryer’s thermistor failed. The dryer is reading the thermistor as “open” and the actual part has shorted out. The thermistor is used to read and control temperatures within the dryer. Beside above, can you reset a Maytag dryer?
How to cancel Maytag Bravos dryer diagnostic code?
Basically with this dryer all you need to do is unplug the dry or flip the circuit breaker off for at least 5 mins. Then power it back on and hit the cancel button twice upon powering back on. Sometimes the F1 error will register on the display upon a power surge or short circuit. Or even when the computer shorts out.
What does F1 mean on Kenmore Oasis dryer?
The “F1” error means that the dryer’s thermistor failed. The dryer is reading the thermistor as “open” and the actual part has shorted out. The thermistor is used to read and control temperatures within the dryer.